Et effectivement c'est malheureusement le problème récurrent de ces manettes.
Voilà une vidéo que j'ai trouvé qui résume bien le problème.
J'ai trouvé un lien de téléchargement sur des fichiers pour une impression 3D de modèles de croix directionnelles ici :
Amiga CD32 joypads by jvdw007www.thingiverse.comI liked what dan_d_builder (thanks for the design Dan) did with replacing the joypad for the Amiga CD32. However, I thought it could go one step further and improve a bit on the stock design.
So I came up with three "improvement" designs.
Pick the one you like and print.
Mine were printed with PLA at 20% infill 0.2mm and came out well. I also made a half dome 6mm width which you can print two of and stick together, to stick on the underside of the joypad prints. I did not test the half dome yet but it should work fine.
Obviously with a bit of cleaning, you should get pretty good results.
I have more ideas for designs (like a mini joystick) but thought some might find that idea odd, so I thought I would start with these 3 for now and see if there is more interest.
I created them using Tinkercad, so I could share them if required.
Unlike some, I quite like the CD32 joypad. :)
Enjoy!
Et je voudrais savoir si une âme charitable a une imprimante 3D qui pourrait m'imprimer et m'envoyer par courrier ces modèles de croix directionnelles moyennant finance bien sûr !
Ce topic peut à l'avenir devenir par extension une plateforme d'échange ou de vente (par mp) d'objets imprimés en 3D.
